Wood Information

Wood types:

This section will help you identify the different wood types of Amish built furniture. It will also help you decide what wood choice is best for your Amish furniture needs.

Woods:

  • Red Oak
  • White Oak (quartersawn)
  • Cherry
  • Hard Maple
  • Hickory
  • Black Walnut
  • Soft Maple (brown maple)
  • Cedar

Janka Wood Hardness Scale:

Janka hardness test is a measure of force required to embed a .444-inch steel ball to half its diameter into the wood. It is one of the most common ways to test the strength and wear of hardwood flooring. The higher the Janka score, the harder the particular species of the wood is.

Janka hardness test is a measure of force required to embed a .444-inch steel ball to half its diameter into the wood. It is one of the most common ways to test the strength and wear of hardwood flooring.

The higher the Janka score, the harder the particular species of the wood is.

Wood’s Natural Characteristics:

  • Cupping
  • Splitting
  • Swelling

Wood01Red Oak:

Amish Furniture Red Oak

Red oak is readily available in the US and Canada. It is the most widely used of the hardwood trees (hardwoods often lose their leaves in the winter) and the trees can reach heights of 100’. Red oak is often plain sawn giving it an open grain pattern. There are multiple trees that fall into the Red oak catagory, one of them is black oak. These woods have a reddish grain pattern and are graded and sold under the name “red oak”.

Plain sawn Red oak can be identified by the wide, flowing ring patterns (fig 1). The annual rings are black in color. They also “indent” into the wood. Run your hand across the black rings and you will notice that area is a bit rougher. Amish furniture Plain sawn cuts can also be identified, on any board, by looking at the end grain pattern. Figure 97 shows the grain pattern clearly.
Amish Furniture

Wood02Red oak measures 1290 on the Janka Hardness scale

 

 

 

 

 

Wood03Amish Furniture White Oak (quartersawn):

 

White Oak is native to the entire eastern half of the United States. Its wood is a light-colored beige that is almost white when freshly cut; hence its common name.

Amish furniture craftsmen like to use quarter sawn white oak. The large trees produce wide planks that have outstanding grain patterns. Quarter sawn wood is very stable and white oak has a natural tendency not to rot or decay. This wood is very stable and resists cupping, twist and cracking when properly finished.

Amish furniture craftsmen recommend using quarter sawn oak if you live in a high moisture area, as the close grain of the wood is very stable.

 

Wood04What is quarter-sawn lumber?

Technically, quarter-sawn lumber has the growth rings of the tree approximately perpendicular to the board’s broad face. In contrast, plain-sawn lumber has the growth rings parallel to the board’s broad face. Quarter-sawn produces both quartered and rift lumber. Look at fig. 104 and note #1;
Amish Furniture
The three red lines on the side of the photo show the growth rings of the tree and they are nearly vertical. This is a true quarter-sawn board. Figure 104, #2 shows a rift sawn board. The growth rings are approximately 30 degrees from vertical.

How is quarter-sawn lumber achieved?

There is only one true way to quarter saw a log. First, Amish furniture craftsmen cut a log into quarters (fig 104). Each quarter is then processed by cutting a single board off of one face, then cutting the next solid wood amish furniture board from the opposite face, and cutting from alternating faces until the quarter is completely cut.

What are the aesthetic qualities of quarter-sawn lumber?

The most notable characteristic of quarter-sawn lumber lies in its incomparable grain patterns. Medullary ray fleck, wavy grain and interlocked grain are all visually enhanced when the log is quarter-sawn. The revival of Mission style furniture is just one example of how today’s Amish furniture craftsmen are re-discovering the unique beauty of quarter-sawn lumber. Today’s Amish heirloom furniture, the antiques of tomorrow, is crafted from quarter-sawn lumber. Quality reproductions and renovations of artisans’ work demand true quarter-sawn lumber. Quarter-sawn wood is the choice of Amish furniture craftsmen.

What are the structural qualities of quarter-sawn lumber?

Quarter-sawn lumber is the uncontested winner when compared to plain- (or flat-) sawn lumber. Quarter-sawn features include:

  • Reduces shrinking and swelling in lumber width.
  • Reduces twisting, warping and cupping.
  • Less prone to surface checking.
  • Does not allow liquids to readily pass through it.
  • Smooth surface as raised grain is not pronounced.

 

Wood05What’s the difference between quartered and rift lumber?

A quartered board features medullary ray or “fleck” perpendicular to a grain which typically forms angles from 60 degrees to 90 degrees with the board’s surface. A rift board exhibits a clean, straight, vertical grain pattern which typically forms angles from 30 to 60 degrees with the board’s surface (fig 20).

 

Is there a difference in cost between quartered lumber and plain-sawn lumber?

Quarter sawing is a specialized technique requiring more time and greater skill to produce. Logically, lumber prices are slightly higher than plain sawn.  However, rustic quarter sawn boards can be used at the same cost as plain sawn lumber.  This is an excellent choice if you want the quality of quarter-sawn lumber, and desire more rustic character such as knots and other minor ‘imperfections’ in the wood.

If quarter sawing is so good, why don’t all sawmills do it?

For most, the art of quarter sawing solid wood for amish furniture has been lost over the years, except for Amish Furniture craftsmen. Like many superior practices of the past, quarter sawing lost favor to plain sawing techniques. Plain sawing is easier, cheaper, and quicker… but it results in more waste, less grain characteristic and less stable lumber.

 

Wood06Amish Furniture Cherry:

Cherry used in Amish furniture is actually called Black Cherry. Cherry is a fine hardwood, but is the softest of the woods Amish use (fig 2). It’s Janka hardness is 950.

Many companies use other similar grained woods that are cheaper, then stain the wood to look like cherry. They then try to sell it for a higher price. Amish Craftsmen only use 100% solid cherry and never cut corners trying to “fake it”.

Buyers note: As you get closer to the outside bark area of a cherry tree the wood will quickly turn from a reddish to an off yellow color. Many Amish like to use boards like this because it gives character to the furniture. Properly laid out boards give a natural beauty to the piece, thus showing the Amish woodworkers eye for perfection.

A rapidly growing woodland tree common throughout all of Ohio, is often found in open fields and previously harvested forests. Its beautiful, fine-grained, orange-brown to mahogany-colored heartwood ranks second only to Black Walnut as the ultimate choice for making Amish solid wood furniture. This tree is named for its ripened black cherries as well as its black-gray, flaky mature bark, which looks like black cornflakes pasted on the trunk of the tree.

A native of eastern and midwestern North America, Black Cherry is a pioneer invader tree in open fields or woodlots, and as such can become a “woody weed” as an aggressive sapling. In youth, it displays a symmetrical, often pyramidal growth habit, but it often divides into several upright branches due to storm damage and assumes an irregular shape as it matures.

How do you identify Cherry?

To the untrained eye it can be difficult to tell if the wood is truly cherry. We teach clients to look for a black grain pattern and a “bit of white” mixed into the wood. These “white” areas are actually the outer edge of the tree. Fig 2 has an arrow pointing to a white spot.

Be aware that Cherry “naturally Darkens” in sunlight!

Cherry that is used in Amish furniture was most likely just built. This wood is actually more “pink” and if sprayed with a natural finish, or clear coat of conversion varnish, it will take up to 6 months to “naturally darken to a golden color”.

Consumer note: DO NOT place anything on a piece of cherry furniture, in a permanent manner, for 6 months. This means decorations, placemats, etc. The sun will not darken the area evenly and you will be left with the shape of the item in a lighter color. The wise consumer will place the extra cherry table leafs in the table so they will darken evenly with the rest of the table.

 

Wood07Amish Furniture Hard Maple:

Hard, or “rock” Maple is a light colored wood that is much harder than cherry. Often referred to as “maple”, this wood has a Janka hardness scale of 1450, and is second in hardness to Hickory. Fig 3 shows a maple boards black growth rings and distinct light color.

Found in the forests and meadows throughout all of Ohio’s Amish Country, but flourishing in the cooler climates and more acidic soils of northeastern Ohio and Appalachia. It is valued for its hard, dense, fine-grained and difficult-to-split wood, which is utilized for floors, Amish furniture, veneer, musical instruments, and railroad ties.

Nearly all Amish furniture built with maple is not stained. Amish finishing shops spray clear conversion varnish on the maple to protect it.

Consumer Note: Many recognize maple by it’s color when sprayed clear, not by it’s grain pattern.

 

Wood08Amish Furniture Hickory:

Hickory is quickly becoming a popular wood for Amish Furniture. Clients love the contrasting color patters (fig.4) when sprayed clear that is not found in today’s mass produced furniture. It takes a skilled eye to glue together wood patterns that are pleasing to the eye and gives each piece of Amish furniture a unique look.

 

Hickory is the hardest wood Amish Craftsmen currently use. It’s Janka hardness scale rating is 1820, or nearly twice of cherry. Hickory furniture is very heavy and will last many generations if properly cared for.

A slow-growing but potentially massive tree scattered throughout Ohio’s Amish Country, is often found in moist bottomlands where Shagbark Hickory usually does not grow. Like other hickories, it’s heavy, dense, strong, yet elastic wood is sought after for making tool handles, athletic equipment, Amish furniture, construction timbers, and firewood, and its wood chips are utilized in the smoking of meats.

As a member of the Walnut Family, it is related to other Hickories and the Walnuts.

 

Wood09Amish Furniture Black Walnut:

Although black walnut is the finest of hardwoods to build Amish solid wood furniture from, many Amish furniture craftsmen are not using it due to high consumer demand for cherry, maple and hickory.

Fig 5 shows a walnut floor with the different color variations.

Black walnut scores a bit better than cherry on the Janka Hardness scale, coming in at 1010.

Its beautiful, fine-grained, chocolate-brown, relatively lightweight heartwood is the ultimate choice for making solid wood amish furniture, interior trim, gunstocks, and high-quality veneer.

A native of the Eastern, Midwestern, and Great Plains regions of the United States, Black Walnut is a pioneer invader tree in open fields or cut-over woodlots, and grows rapidly in youth. A rapidly growing tree is most common in moist bottomlands and open fields, but is found everywhere due to squirrels burying its nuts.

Brown-Soft Maple: (no photo available)

Soft maple is a lumber term, not species of tree. This normally refers to the cousin of the hard maple tree. Amish craftsmen often use soft, or brown maple as many Amish refer to it, for paint grade pieces. This wood is about 25% softer than hard maple and places it in the category of cherry and walnut. The wood is usually straight grained and smooth. Amish furniture craftsmen are using brown maple in their solid wood furniture. Amish craftsmen are using modern day dye stain techniques to give the wood a different look. One popular color of dye stain is “Expresso”. This dye stain gives a very dark, rich color to the wood and it is lower in cost than cherry.

Consumer note: Amish like to use soft maple for their painted and dye stained furniture.. The lower cost of the wood and saves the consumer money. The smooth grain pattern takes the paint very well giving a smooth, rich finish.

 

Wood10Amish Furniture Cedar:

While also known as Cedar or Red cedar, this species is actually a type of Juniper, reaching a height of 30 feet and width of 15 feet when found in the open, although it is spire-like in youth. Fig 108 shows a piece of rustic red cedar furniture

Its aromatic heartwood is lavendar-red in color, and is prized for making Amish cedar chests, closet wood lining, cedar shavings, and small Amish carvings.

Many Amish furniture craftsmen that use Cedar for their log style furniture often spray a clear finish over the wood to protect it.

Wood Characteristics:

Wood11Amish Furniture Cupping:

Cupping is referred to when a boards edges start to curl up or down relative to the center of the board (fig 13).

This is caused by an imbalance of moisture in the wood. Your best reference of cupping may be your deck. Because the board is exposed to constant sun, wet, cold, and hot conditions on the exposed side of the board, and very little sunlight and moisture on the bottom, the board cup’s.

This allows more moisture to sit on top of the board because the sides are higher than the center, thus creating more problems.

What to do?

Amish furniture craftsmen are aware of the problem and take steps to prevent cupping. First, they glue boards with the grain patters going opposite directions. They also seal the top AND the bottom of the boards. This limits the amount of moisture that can penetrate the wood. The client must also do their part by keeping moisture off the wood and if it’s outdoor Amish furniture they should use a wood sealer.

 

Wood12Amish Furniture Splitting:

One of the challenges of solid wood furniture is controlling the wood from splitting (fig 109).

Amish craftsmen work hard to prevent this from happening. The process actually starts when the log is cut. The ends of the log, which are shaped like little straws carrying nutrients through the tree, are more porous and easily shed moisture. This imbalance in the moisture content of the wood can cause splitting.

Splitting also occurs when the Amish craftsmen does not get enough glue on the seam of two boards. It should be noted that glue is actually stronger than the wood. Often a split or crack will form next to the glue joint, but not on the joint.

What to do?

The Amish have done most of the work for you by sealing the end grains with Conversion Varnish. This stops the flow of most moisture into the wood.

The consumer’s job is to limit the Amish furniture from direct sunlight. The sun is trying to dry the top of the wood faster than non exposed areas. The consumer must also control the humidity levels in the home. From summer to winter your home’s moisture will change. Your furniture was built to “move” with the changes by the Amish craftsman building floating panels in the doors, using screws to connect pieces were the grain patterns change direction, etc.

There is a tremendous amount of thinking, along with superior craftsmanship, that goes into each piece of Amish built furniture.

Swelling:

Swelling occurs when the ambient moisture level in your home changes. This is often found during summer months in homes with no climate control (no air conditioning). The wood is constantly trying to stay balanced with the humidity level of the room. If the Amish furniture is not sprayed with a film finish (conversion varnish) the wood will take moisture until it balances with the humidity level of the room, causing swelling.

Consumer note: One place the wood swells is the solid wood leaves of dining tables. This is natural and will change through the seasons. This is not an Amish Craftsman defect, just nature taking it’s course.

 

 

Leave a reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>

*